How to use Launch X431 X-Prog3 with PC Adapter to clone ISUZU Bosch MD1CS089 ECU?
Check the guide below.
Procedure:
Connect X431 PC Adapter to X-Prog3 Key Programmer and computer
Open X-Prog3 PC Adaptor PC software
Input “md1cs089” in the search box to find the corresponding car model (Isuzu D-Max 2005-2020 MD1CS089 ECU)
Select “BENCH” connection type and click “Next”
Check the Direct connection of diagram and follow it to connect X-Prog3 PC Adaptor and ISUZU ECU correctly
Ensure the device connection is correct, and start to perform the reading and writing functions.
Back up the original ISUZU MD1CS089 ECU data:
Connect>> Read EEPROM data >> Read FLASH data>> Disconnect
Note: Remember to save the original EEPROM data and Flash data after reading
Back up the new ISUZU MD1CS089 ECU data:
Repeat the same steps as original ECU to back up the new ECU data
Finally, write the original ISUZU MD1CS089 ECU data into the new ECU
Done!